The switch backside bigspin is a difficult and technical skateboarding trick that involves spinning the board 360 degrees while rolling switch backside. It is a trick that requires a lot of practice and dedication to master. In this blog post, we will guide you through the steps to switch backside bigspin on a skateboard.

Step 1: Foot Placement

Before attempting a switch backside bigspin, make sure your feet are in the correct position. Place your back foot on the tail of the skateboard, and your front foot just behind the front truck bolts. Keep your feet perpendicular to the board and about shoulder-width apart.

Step 2: Approach and Pop

Approach the obstacle or area where you want to perform the switch backside bigspin. As you get closer, crouch down and pop the tail of the skateboard with your back foot. This will create an upward motion for the board.

Step 3: Turn Your Shoulders

As you pop the tail, start to turn your shoulders in the opposite direction you want to spin. In this case, you want to turn your shoulders towards the frontside of the board. This motion will initiate the spin of the board.

Step 4: Flick and Slide Your Front Foot

As the board starts to spin, use your front foot to flick the board in the opposite direction you want to spin. At the same time, slide your front foot towards the back of the board. This motion will cause the board to spin in a 360-degree rotation.

Step 5: Land and Roll Away

As the board completes its 360-degree rotation, make sure to land with your feet over the bolts, and your knees bent to absorb the impact. Keep your eyes focused on the landing spot, and roll away smoothly.

Remember, mastering the switch backside bigspin takes a lot of practice and patience. Start by practicing on flat ground before attempting it on obstacles like curbs, ramps, or stairs. It may take some time before you can switch backside bigspin consistently, so don’t get discouraged. Keep practicing, and with time, you’ll be able to switch backside bigspin higher and with more style.

In conclusion, the switch backside bigspin is a challenging and technical skateboarding trick that requires a lot of dedication and practice. With the right foot placement, pop, turn, flick, slide, and landing, you can master this trick. Always wear protective gear like helmets, knee and elbow pads, and wrist guards when skateboarding to avoid any injuries. Happy skateboarding!

Author: Kyle Niedz

sk8brdr